![]() The procedure, as you have seen, is quite simple. If a pump isn’t available, you can also drain out the few inches that are left using a bucket.You may have to use a pump to remove the remaining water. Few inches of water may remain in the pool after you’ve siphoned it with a hose.You can remove the brick and take out the hose from the pool.Once the water has stopped coming out from the end of the hose that’s at the drainage location, the siphoning process is complete.Return to the pool and check if the water is draining out correctly.Upon reaching the drainage spot, remove the hose cap and set it down where the water is to be drained.Make sure that the level of hose is higher than the water in the pool, while you carry it. Carry this hose end, that you have removed from the faucet, to the spot you’re going to drain the water.Make sure you hold the hose above the level of the water in the pool. Remove the hose from the faucet and cover it with a hose cap.Once water appears at the other end and flows into the pool, turn off the outdoor faucet.Turn on the faucet from the other end and let the water flow through this end for a few seconds.Now that you have set up the siphon, here’s how to siphon water with a hose: Taking this step will prevent the hose from sliding out of the pool. You may want to place a brick over the hose at the point where it crosses over the wall of the pool. ![]() ![]() Place this end of the hose into the pool until it is completely submerged in water. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |